Pensacola Fishing Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,851 Posts
The prop shop can weld a new one on while still on the boat. Bill Matthews @ 455 0060. They are on Navy Blvd. next to NAPPA. They simply trim up the drive and add water to the carrier bearing/exhaust housing and the O-rings and seals never get over the temp. of boiling water.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top