Pensacola Fishing Forum banner
1 - 10 of 10 Posts

·
2201 Mako
Joined
·
24 Posts
Discussion Starter · #1 ·
Where can I get some aluminum rod holders made for the bed of my truck. I would like to bolt them by my back window, looking up and Maybe with a 15 or 20 degree tilt. Would like them to hold 4 rods or so. Thx for any help.
 

·
Registered
Joined
·
14,582 Posts
You would probably be better off with stainless steel.
Last month I wanted to buy two that clamp on to the bow rail.
I looked all over town and they were $60-$70. I then Google it. And found them for $15 apiece. Amazon prime. They were here the next day. While I was doing my search I saw lots of what you are looking for.
 

·
Bearded Brotula
Joined
·
14,955 Posts
I built one for my truck using starboard.
 

Attachments

·
Registered
Joined
·
11,596 Posts
You would probably be better off with stainless steel.
Last month I wanted to buy two that clamp on to the bow rail.
I looked all over town and they were $60-$70. I then Google it. And found them for $15 apiece. Amazon prime. They were here the next day. While I was doing my search I saw lots of what you are looking for.


Same here, and were better quality than I expected for the money!
 

·
Registered
Joined
·
1,974 Posts
I made my own for my silverado but it fit on the side between the front of the bed and the wheel well. That way, I had the full length of the bed to load stuff. Had spots for 4 rods on each side.
 

·
Bearded Brotula
Joined
·
14,955 Posts

·
Super Moderator
Joined
·
29,873 Posts
1 - 10 of 10 Posts
Top