Pensacola Fishing Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1,503 Posts
If it's not epoxy, you can gently scrape it off with a sharp knife holding the blade perpendicular to the rod blank. Then sand with fine sandpaper. Solvent may work on some old glues.If it is epoxy, you might be able to sand it down enough to work with when replacing the handle and seat. I wouldn't worry about making it to pretty if it's going to be hidden under the new handle.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top