Pensacola Fishing Forum banner

1 - 8 of 8 Posts

·
stonecoldshooter
Joined
·
1,757 Posts
Discussion Starter #1
My power inflator button has begun to leak. Tiny stream of bubbles coming from (looks like) under the button. Can the button be disassembled? Is there a seal under the button? Is this BC shot?



Any thoughts would be appreciated.
 

·
Jiggin Finatic
Joined
·
8,548 Posts
Most power inflators can be rebuilt.
 

·
Registered
Joined
·
1,371 Posts
Most can be rebuilt, or worst case the power inflator can be replaced. Bring it by MBT and we'll get you fixed up, usually only takes a few minutes to rebuild.
 

·
stonecoldshooter
Joined
·
1,757 Posts
Discussion Starter #5
Thanks guys. I will be by the shop this week.
 

·
Registered
Joined
·
422 Posts
jspooney (2/8/2010)what does it cost to get a power inflator rebuilt? Mine leaks too.


Usually not too much, I am sure someone will let you know. Worst case would be to replace the hose, best case it is some sand and grit and maybe replace an O-ring. You never really know until it is apart.



What kind of BC is it? PM sent on a different subject.
 

·
Registered
Joined
·
1,371 Posts
Complete power inflator rebuild is $20. Not all of them need a full service, sometimes it doesn't cost anything, just depends on what the problem is. Worst case, a new power inflator is around $40.



Bring it by MBT and we'll be ahppy to take a look.



Jim
 
1 - 8 of 8 Posts
Top