Pensacola Fishing Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
I need to replace the drain tube from my storage & fish box. I bought the new tube with the one end already flaired. When I pushed the tube in with the flair on the out side the flair bottoms out at the top with a 1/4 in gap at the bottom. I bought the tool with the two ends that flair with a bolt going through the middle. I'am just not sure what going to happen to the out side flair when I tighten up on the bolt. Any thoughts?? I need to think outside of the box. Thanks
 
1 - 1 of 1 Posts
Top