[T140]

​

1950 Allis Chalmers Model WD. Runs very well, good oil pressure and holds temperature at 170-200 range. 30 hp tractor ready for a restoration to show or to make a good pulling tractor. Comes with a two bottom plow attachment. It has rear hydraulics

. that work fine, but it is not a regular3 pt. hitch. PTO Shaft. Tires are in fair 50-75% condtion.$1800 takes it. 850-393-1415

 

[Nordman1]

Please explain the hydraulics if it is not a three point hitch. Is it gas or diesel?

 

[Framerguy]

Lookssimilar to the old 2 point Eagle hitches that Case used on their SC tractors.

 

[T140]

Allis Chalmers called their hitch a "snap coupler" system. The two arms shown has a coupler on the end that opens, connect to implement via a pin and then flip the coupler down and it makes a snap sound, the implement has a hook that goes into a bell coupler under the tractor where the drawbar is shown. There is a conversion kit available to make it a regular ferguson type 3 point hitch.

for more info: http://www.oktractor.com/which.htm

It is a gas fueled tractor.

 

[Nordman1]

So how hard are implements to come by?

 

[T140]

Depends on what you are looking for. 2 bottom plow comes with it. A pull behind bush hog are not too hard to frind, I have seen disc on Ebay. conversion kit would allow you to use any 3 pt hitch implement.

 

[Mike aka FishWerks]

Nice tractor, looks like a work horse.