Pensacola Fishing Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Helping out a 15 yr old young man with his first boat. 2000 Skeeter 20' with a 200 Yamaha hpdi. Having some trouble with the power trim. It has 3 different switches - motor, helm and in front next to the trolling motor. Motor will raise but blows a fuse when the it is lowered. Replaced the relay and took out front 2 switches with the same result. Trim motor runs in both directions when tested connected directly to a battery. Trim switch tests good with volt meter.

Anyone know where I can get a schematic or have any insight into what else to look at?


thanks
 

·
Registered
Joined
·
4,265 Posts
It’s just three wires from each switch. Blue, green and red. Disconnect and test each switch separately. They all tie in together before the relay. If each switch has the same result then it’s a engine end issue, pretty simple system.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
It’s just three wires from each switch. Blue, green and red. Disconnect and test each switch separately. They all tie in together before the relay. If each switch has the same result then it’s a engine end issue, pretty simple system.

Green wire is shorted to ground - Just can't find where yet. May just run a new wire but I'll do a little more looking. Thanks for the responses
 
1 - 4 of 4 Posts
Top