X-Shark

Hello X Shark.
I haven't logged in here in a while. I'm also a member of classicmako forum. But I don't post much. I have a 1988 Mako 254 that needs a new transom. And was wondering if you could do the repair and what it might cost? I live in Midway/Navarre and can bring the boat to you. I've seen your work and have been blown away by the craftsmanship.
My name is Sean Maloney. My # is 850-23-8884. I do shift work so if I don't answer just leave a message and time to call you back. Or my email is scm67@hotmail.com. Thanks!
If nothing else I coul really use some advise on what the boat really needs.

Hey you replied back to a thread I posted this past morning. What do you suggest I do with the stufff I currently have the 900 Watt genny the 2 sea striker lights and I also have 4 work lights I can change the bulbs out on I want to use the genny I currently have and I want to have the most suffecient light I can have without going over the suggested specs on the genny give be some ideas I can even go as far as adding another sea striker light in the center if that is what's needed any info would be appreciated

Bob,

I have a 31 gallon gas fuel tank that needs to be leak tested. Can you do that for me? If so please send me your address or any replies to krawson81@mediacombb.net.
If the tank is fine it will also need the coal tar epoxy applied. Do you have any?
Thank you,
Keith Rawson (Ocean Master)

It's a1990 21 cape horn and needs the whole floor redone do you have a ballpark estimate

Hey Bobby, This is George Johnson. i've been on the road for about 9 months now and I was wondering how Coco has worked out for you so far? I hope all is ok and thank you again for giving him the attention he deserves!
George

Bobby

I'm shopping for a new ride,something along these lines
23 regulator, 24 capehorn, 24 mckee, 24 pursuit, 25 seavee

keep your eye out and let me know if tou see anything around for sale

hey buddy, I've been trying to call you for days.....must not have right number. When you get a chance, call me re: depth finder. Bottom line, i already made the decision but would still like to run it by the "expert!!"" 207-0933

Got a copy of a email yesterday. Full of incorrect information ect. My sons as well as myself would like a meeting with you. A call from you would be appreciated! Tim @ 554 6172

Bobby, hello, hope all is well. I'm repainting a 21 Chris Craft (Fiberglass) that has some spider/stress cracks. I'm not so concerned about it being like new but was curious if a primer would cover/fill these or would they have to be ground and filled, which I don't want to spend the time or money on. After all the research I plan on using Interlux perfection either paying someone or doing it myself. Any help is greatly appreciated. Thanks, SHB

Need some lighting advice....please. Currently I have 10 500 watt halogens. I want to replace the front 4 with 400 w hps lights. Will that cause any problems (generated wise?) My generator is rated at 6,000 watts.
thanks.
john